• Pollutant Management

    Waste water management

    All the factories have granted government approved "water pollution prevention measures" and "permit for effluent", as well as setup wastewater treatment facilities based on the prevention measures. All the wastewater treatment facilities are operated in accordance to the prevention measures and the amount and quality of the effluent are regularly tested and reported to the authorities. The rest results are all below the effluent standard. In addition, the factories are located in industrial area and/or industrial zone where do not have bio-sensitive sites nearby. Therefore the effluent from Tatung will not have significant impacts to the biodiversity of the recipient water bodies.

    Wastewater treatment and effluent status in 2018

    Factory Treatment method Average COD concentration(mg/L) Average SS concentration (mg/L) Amount of effluent (M³) Recipient water body Effluent reused by others
    San-Hsia Factory
    Factory owned wastewater treatment plant in accordance to the requirement by the regulation
    17.32
    8.59
    7,967
    Heng River
    None
    Tayuan Plant
    Concentration is below the detection limit.
    2.50
    2,865
    New Street River
    Taoyuan Wires and Cables Plant
    Concentration is below the detection limit.
    2.65
    52,145
    New Street River
    Taoyuan 1st Plant
    11.14
    5.25
    10,590
    Old Street River
    Total
     
    -
    -
    73,567
     

    Note: The effluent standard COD: 100, SS:30.



    Air pollutant emissions and management

    The main air pollutants from the factories are NOx, SOx, and VOC. Tatung declares the amount of emissions and pays air pollution control fee to the authority. The emissions of VOC have reduced gradually since 2015 and the emissions for NOx have slightly increased. The reason could be more diesels were consumed by RTO.

    Tatung sets up and operates air pollutant treatment facilities in the factories in accordance to the regulation. Pollutant concentration is regularly tested and met the standard. In addition to meet emission standards, we are committed to optimize the air quality around the factories. In the past few years, we have implemented pollutant removal facilities with higher removal efficiency, such as RTO (Regenerative Thermal Oxidizer). We have added a set of RTO at Tayuan Plant in 2018 and obtained operation permit from local authority. In 2019, we are going to change the part of treatment process from activated carbon adsorption to existing RTO in San-Hsia Factory to reduce the impact on the surrounding environment.

    ▲ NOX and SOX emission trends

    ▲ Air pollutant emission(VOCs)

    Waste reduction and management

    Tatung's waste reduction concept is mostly from product design and process improvement to reduce the amount of industrial wastes. The wastes produced are properly classified and stored according to relevant regulations, and finally commissioned by domestic qualified treatment companies or reuse companies. Tatung audits the entrusted companies from time to time to ensure that the wastes are properly cleaned up.

    ▲ Tatung wastes clean up and treatment process

    In 2018, Tatung produced 2,862.98 tons of industrial wastes, of which 2,832.90 tons were general industrial wastes and 30.08 tons were hazardous industrial wastes. Although the amount of wastes have been reduced by 32% in the past 5 years. However, compared with year 2017, the amount of wastes produced in 2018 was only 4.07% less which did not meet our waste reduction target of 5% per year. We will continue to work hard through green design to reduce the amount of wastes in the future. In 2018, 2,074.85 tons of wastes were reused (72.47% of total wastes). The reuse rates in the past 4 years were all above 70%.

    ▲ Amount of industrial wastes

    ▲ Wastes reuse percentages in the past 4 years

    Latest update: 2019.10.15